Quick answer: A direct repair is usually best for a first leak in otherwise healthy pipe under carpet or concrete. A reroute is usually better when the pipes are old, you have had leaks before, or the leak is under flooring you do not want to break.

The two options in plain terms

Direct (spot) repair: the floor and slab are opened over the leak, the damaged section of pipe is replaced, and the concrete is patched. It fixes this leak only.

Reroute: the leaking line is capped and abandoned in the slab, and a new line, usually PEX, is run through the walls, ceiling, or attic to the same fixtures. The floor is not touched, and that line can never leak under the slab again.

Six questions that decide it

  1. Is this the first leak? A second leak is a strong sign the rest of the pipe is wearing out. Lean toward rerouting.
  2. How old are the pipes? Original copper in a 1950s to 1970s home argues for rerouting.
  3. What flooring is over the leak? Carpet or bare concrete favors a spot repair. Tile, stone, or hardwood favors a reroute.
  4. Is it a hot or cold line? Hot-water lines tend to fail again; rerouting all hot branches at once is a popular middle ground.
  5. Is there attic or wall access? Single-story homes with an attic are easy to reroute. Some split-level homes take more work.
  6. How long will you stay in the house? If you plan to sell soon, a spot repair may be enough. If you are staying, a reroute or repipe buys peace of mind.

Common scenarios

  • First cold-water leak under bedroom carpet: spot repair is usually the sensible choice.
  • Hot-water leak under kitchen tile: a reroute through the attic often costs less than repairing plus replacing tile.
  • Third leak in ten years: a partial or whole-house repipe ends the cycle.
  • Leak under a garage slab: spot repair is simple and the floor is cheap to patch.

Myths to ignore

  • "Rerouting always costs more." Not once flooring replacement is counted.
  • "PEX is a cheap, temporary fix." PEX is widely used for reroutes and repipes and is not affected by hard or corrosive water.
  • "Leaving the old pipe in the slab is a problem." Abandoned lines are capped and do no harm.
  • "A reroute leaves holes everywhere." Openings are small and patched; ask whether texture and paint are included.

Make the decision with real numbers

Ask for two prices: a spot repair including flooring restoration, and a reroute including drywall patching. Compare totals, warranties, and how many more leaks each option leaves you exposed to. The cost guide has typical ranges, and the slab leak repair page can connect you with a local specialist.

People Also Ask

Common questions

Is rerouting better than repairing a slab leak?

Often, for older pipes or leaks under finished floors, because it retires the problem pipe and leaves the floor alone. For a first leak in healthy pipe under carpet, a spot repair is usually fine.

How long does a slab leak reroute take?

A single-line reroute is usually finished in one to two days.

Does a reroute need a permit?

Reroutes and repipes are generally permitted work. Ask the contractor to pull the permit and schedule the inspection.

Will a reroute affect water pressure?

A properly sized reroute should not reduce pressure, and replacing old pipe can improve it.

Can only the hot-water lines be rerouted?

Yes. Rerouting all hot-water branches is a common middle option, because hot lines usually fail first.