Single-line reroute
Only the leaking line, often a hot-water branch to a kitchen or bathroom, is replaced with a new overhead or in-wall run. The old pipe is capped and left in the slab.
Replace or reroute the aging water pipes buried under your foundation for a long-term fix. Compare PEX and copper reroutes, partial reroutes, and whole-house repipes with a local plumbing specialist.
Call Now · (310) 928-3074
Under-slab pipe repair deals with the plumbing system itself, not just one leak. When the water lines under your foundation are old, corroded, or have leaked more than once, the long-term fix is usually to take them out of service and run new lines where they can be reached: through the walls, the attic, or along the exterior.
That can mean rerouting a single line (often the hot-water line, which fails most), rerouting several fixture branches, or repiping the whole house. Each step up costs more but removes more risk. Many homeowners decide after a second or third leak that it is time to stop patching.
If you have one active leak right now, start with slab leak detection and read about repair options. This page explains the bigger-picture decision.
| PEX | Copper (Type L) | |
|---|---|---|
| Cost | Lower material and labor cost | Higher material and labor cost |
| Install time | Faster; flexible lines need fewer fittings | Slower; rigid pipe needs more soldered joints |
| Wall and ceiling openings | Fewer, smaller openings | More openings for straight runs |
| Freeze and movement tolerance | Flexes; tolerates movement well | Rigid; joints can stress over time |
| Water chemistry | Not affected by corrosive or hard water | Can pit with aggressive water over decades |
| Sunlight exposure | Must be protected from UV | Not affected by UV |
| Typical lifespan | Rated for many decades | Often 50+ years with good water |
Your provider will recommend a scope based on pipe age, leak history, and budget.
Only the leaking line, often a hot-water branch to a kitchen or bathroom, is replaced with a new overhead or in-wall run. The old pipe is capped and left in the slab.
Several fixture branches, or all hot-water lines, are rerouted at once. This is a good middle ground when the hot side keeps failing but the cold side has held up.
Every supply line in the home is replaced and the under-slab plumbing is retired. It costs the most up front but ends the cycle of slab leaks.
Lines run through the attic and drop down inside walls to each fixture. Common in single-story ranch homes, with insulation added in hot attics.
Where there is no usable attic, lines can run inside walls or along the exterior in protected, insulated chases.
Small drywall openings are patched and textured. Ask whether painting is included, or whether you should plan for a painter.
Rancho Palos Verdes is served by California Water Service's Palos Verdes District, which delivers imported water that is moderately hard. Over decades, water chemistry plus constant pressure wears copper from the inside. On top of that, the city's expansive clay soils and hillside settlement keep flexing slabs. Pipes cast into concrete cannot move with them.
Single-story homes in neighborhoods such as Los Verdes, Mira Catalina, and Eastview often have accessible attics, which makes overhead PEX reroutes straightforward. Split-level and hillside homes in Miraleste and Crest can need more creative routing, so a walk-through before pricing is worth it.
Rerouting also takes the pipes out of the ground in areas affected by slope movement, so the plumbing is no longer at the mercy of the soil.
Cost scales with how much pipe is replaced, the number of bathrooms, the material, and how easy the routing is. A single reroute is a modest job; a full repipe of a large hillside home is a major project.
Ranges are general industry figures for planning only, not quotes. Los Angeles County labor rates often sit at the upper end. The written estimate from the provider who inspects your home is the number that counts. See the full slab leak repair cost guide and what insurance covers.
| Job | Typical range |
|---|---|
| Single-line reroute | $1,500 – $5,000 |
| Partial reroute (several branches) | $3,500 – $8,000 |
| Whole-house PEX repipe (2 – 3 baths) | $6,000 – $12,000 |
| Whole-house copper repipe | $10,000 – $20,000+ |
| Drywall patching and paint | Often extra; ask |
Calls are taken from every part of the city in ZIP codes 90274 and 90275. See the neighborhood pages for local details, or the Rancho Palos Verdes slab leak repair overview.
For older copper, usually yes. Rerouting retires the problem pipe, avoids breaking concrete, and protects your floors from the next leak. A spot repair only fixes the current hole.
PEX is widely used in California for reroutes and repipes. It is flexible, fast to install, and not affected by hard or corrosive water. Copper is still a solid choice if you prefer it and the budget allows.
Many single-family homes are repiped in two to five days. Water is usually restored at the end of each workday.
Repiping is generally permitted work. Ask your contractor to pull the permit with the City of Rancho Palos Verdes and schedule the inspection.
They are cut and capped at both ends and left in place. Removing them would mean breaking up the floor for no benefit.
Tired of repeat slab leaks? Call now to talk to a local specialist about rerouting or repiping.
Call Now · (310) 928-3074Free referral service. Your call connects you with an independent local provider.