Quick answer: A technician first confirms there is a leak and which line it is on, using your meter and pressure tests. Then they pinpoint it with listening equipment and often thermal imaging, and mark the spot on the floor. Most visits take one to three hours, and no concrete is broken during detection.

Before the visit

Clear the floor around any warm or damp spots, and make sure the technician can reach the water meter, the main shut-off, and the water heater. Write down what you have noticed and when it started, and have a recent water bill handy. If you have done a meter test yourself, share the results. It saves time.

Step 1: Confirm there really is a leak

The technician turns off all water use and watches the meter. If it moves, they isolate parts of the system, closing the house valve and then the water heater inlet, to work out whether the leak is in the yard line, on the cold side, or on the hot side. Toilets and fixtures are checked so nothing obvious is missed.

Step 2: Pressure-test the suspect line

Each line is isolated and pressurized, with a gauge attached. A line that steadily loses pressure is leaking. This step turns "I think there is a leak" into "the hot-water line to the kitchen is leaking", and rules out the parts of the house that are fine.

Step 3: Pinpoint the leak

Now the search narrows to a spot on the floor. What you will see and hear:

  • Line tracing: an electronic locator maps where the pipe actually runs under the slab.
  • Acoustic listening: the technician moves a ground microphone across the floor, wearing headphones, following the sound of escaping water to its loudest point.
  • Thermal imaging: for hot-water leaks, an infrared camera shows the heat spreading through the slab.
  • Tracer gas: for very quiet leaks, a safe gas mix is pushed through the line and detected where it rises through the concrete.

Good technicians confirm a reading with a second method before marking the floor, usually within one to three feet of the leak.

What you should get at the end

  • The leak location marked on the floor, with photos
  • Which line is leaking (hot or cold, which branch)
  • A short written report, which helps with an insurance claim
  • Repair options: spot repair, reroute, or repipe, with a written estimate

Detection is usually a flat fee. See the cost guide for typical prices, and the slab leak detection service page to get connected with a local specialist.

People Also Ask

Common questions

Does slab leak detection damage the floor?

No. Detection uses pressure tests, listening equipment, thermal cameras, and tracer gas, none of which break the floor. Concrete is only opened later if you choose a spot repair.

How long does slab leak detection take?

Most visits take one to three hours. Large homes, several leaks, or very quiet leaks can take longer.

How accurate is slab leak detection?

An experienced technician usually pinpoints a leak within one to three feet, especially when two methods agree.

Do I need to be home during leak detection?

Yes, or someone who can give access to the house, the meter, the main shut-off, and the water heater.

Should the detection company also do the repair?

It can, and some credit the detection fee toward the repair. You are still free to get a second repair quote using the detection report.